Coffee Machine
Page 3
Before first use
Before first use or after long storage the
coffee maker should be flushed through.
•
Site the coffee maker on a level stable
surface - the rubber feet should all fully
contact the surface to ensure stability.
•
Slide the water tank 10 upwards and
remove. Fill to the MAX level shown
on the casing with cold water. Replace
water tank, ensuring the valve at base is
properly seated.
•
Lock-in the filter handle
13 by twisting it
anti-clockwise into the
bayonet housing 12 .
•
Turn the steam control 9 clockwise to
MIN.
•
Set the control knob 2 to OFF setting
4 .
•
Plug the power cable 17 into your socket
(check your supply is compatible with the
Rating Information - page 8).
•
Turn the control knob 2 to power &
heat setting 5 . The water in the boiler
will start to heat.
•
Place a heat proof jug under the steam
tube 11 .
•
Rotate steam control knob 9 anti-
clockwise to MAX.
•
Wait a few minutes for the water to
boil, then turn control knob 2 to pump
switch position 7 - water will flow from
the steam tube 11 .
•
After cleaning return the control knob 2
to power and heat ON setting
5 , and steam control knob 9 clockwise
to MIN.
•
Place the heat proof jug under the filter
handle 13 .
•
Turn the control knob 2 to pump switch
position 7 and water will flow from the
filter handle 13 .
•
Return the control knob 2 to power and
heat ON setting 5 .
How to use
Making coffee
The cup warming plate 1 will become
warm as the coffee maker heats - stand the
clean, dry cups on this plate before brewing.
Using Ground Coffee
•
Fill the water tank 10 to the MAX mark.
•
Start heating the water by turning the
control knob 2 to power and heat
switch position 5 . The warning light
6 indicates that the thermostat is
controlling the temperature of the water.
•
Add ground coffee to the coffee
container 22 using the measuring spoon
18 and tamp down using the tamper
19 , following the MAX level mark.
The strength of the Espresso depends
upon how tightly the ground coffee is
compacted in the coffee container. If it
takes more than just a few minutes for
the coffee brew to flow into the cups,
then the ground coffee has either been
ground too finely, or has been compacted
too tightly in the filter.
•
Load the coffee container 22 into the
filter handle 13 . Lock-in the filter handle
13 by twisting it anti-clockwise into the
bayonet housing 12 .
•
Place a cup on the centre of the drip tray
cover 14 .
Before first use (Continued)
