Steinberg Nuendo Time Base, Operation Manual, Page: 54 / 92

TIME BASE
5 – 54 Reference
LTC output, Preroll, USB port and System Video settings –
Display page P.5
❐
The described LTC Slave mode is of limited use, as no return messages can
be interpreted from the LTC Slave.
Parameter Explanation
USBPORT: OFF The USB port is switched off.
USBPORT: ON The USB port is switched on.
Parameter Explanation
LTCOUT=TCIN The LTC output sends the Time Code selected in P.1 under TC
IN (+ Offset).
LTCOUT=Standing
The LTC Generator is always active, even during Stop or FF/
Rew, when it generates standing or winding code.
LTCOUT=LocBurst
In addition to normal Time Code, on receipt of a Locate com-
mand, a short burst of Time Code with a Locate address minus
Preroll will be sent. This allows you to use a LTC-Slave Machine
(e.g. DA88) together with a 9-pin Video Machine.
USBPORT:OFF SYS-VIDEO:25
LTCOUT=TCIN PREROLL=-00:00 P.5
USBPORT:OFF SYS-VIDEO:25
LTCOUT=TCIN PREROLL=-00:00 P.5