Steinberg Nuendo Time Base, Operation Manual

Page: 52 / 92

TIME BASE
5 – 52 Reference
Time Code Test and Offset – Display page P.4
• Tape machines, mixers and HD Recorders must support this function!
Parameter Explanation
TC OUT Output of regenerated Time Code…
TC OUT=Direct …as soon as its validity has been established (TCVAL).
TC OUT=OnLock …after validity check and successful system lock. This ensures,
that a sequencer/HD Recorder is only started if the Word Clock
is in phase.
TC OUT=JamStart …after validity check the internal Time Code Generator can be
started in sync with incoming Time Code (when the cursor is under
WAIT and switched to RUN/ P:1) and runs until set back to WAIT.
Parameter Explanation
OFFSET=xx:xx:xx
The time value entered here is added to the incoming value dur-
ing the Time Code Regeneration.
In Time Code Generator Mode the Offset is ignored.
Parameter Explanation
MTC STD Sets which MIDI Time Code data will be sent.
MTC STD=Standard Only MTC Running Data (Quarter Frame Messages) are sent.
MTC STD=FF Loc Full Frame Message, for example VITC Slow Motion or TC9 are
additionally sent. The transport position is always precisely dis-
played even during SloMo and FF/Rew in Nuendo, or a HD Re-
corder and/or Digital mixer.
TC OUT=OnLock OFFSET=00:00:00:00
MTC STD=STANDARD TCVAL=07F DROP=05F P.4
TC OUT=OnLock OFFSET=00:00:00:00
MTC STD=STANDARD TCVAL=07F DROP=05F P.4
TC OUT=OnLock OFFSET=00:00:00:00
MTC STD=STANDARD TCVAL=07F DROP=05F P.4