Steinbach HJ1103, Original Owner'S Manual

Page: 25 / 185

1. Hold the device by the handle
10
and lower it
slowly into the water until all the air has
escaped.
2. Carefully lower the device to the bottom on the
nylon cord of the floating handle.
Make sure that the device lands on the bottom
of the pool on its underside and that cleaning
can start without obstruction towards the center
of the pool.
The status indicator
12
blinks blue.
The device is in the pool and starts cleaning with a
time delay.
Switching off the device
Proceed as follows to switch off the device:
1. Lift the device out of the pool and switch it off.
2. Clean the filter unit and the device.
Stopping cleaning
The device stops cleaning automatically as soon as the rechargeable battery is almost discharged. The
status indicator
12
is lit red while the device moves to the pool wall.
Lifting the device out of the pool
1. Slowly pull the device to the surface by the floating handle
6
and the nylon cord until you can
reach the handle
10
.
2. Slowly lift the device out of the water by the handle
10
and hold it above the water surface.
After 10 to 15 seconds, most of the water that has collected in the housing has drained back into
the pool.
3. Set the rotary switch
8
to OFF.
The status indicator
12
blinks red once and the device switches itself off.
4. Set down the device next to the pool.
The device is lifted out of the pool.
Clean the device after each use to ensure continued trouble-free operation.
Cleaning
Only clean the device with a standard bathroom cleaner, clear tap water and a lint-free cloth. Aggressive
cleaning agents can damage the device. Dry the product with a lint-free cloth.
10
25
en