Steinbach 061207PP, Original Owner'S Manual

Page: 25 / 195

Configuring the cleaning program via the app
You must pair the device with the app and configure the cleaning program while the device is out of the
water before placing the device in the pool and starting cleaning. Any settings you have made are saved
and applied in future operation.
1. Activate Bluetooth.
If you use an Android device, you might have to activate GPS as well.
2. Press the ON/OFF switch
6
.
The status indicator
5
is lit blue. The device is ready for operation.
3. Press the ON/OFF switch a second time (within max. 2 seconds).
The status indicator
5
blinks pink. The device is ready to connect to the app via Bluetooth.
4. Start the "Battery Pro Line" app.
5. Search for available devices.
6. Select your device to connect it to the app.
The app signals the successfully established connection. The status indicator
5
is lit pink. The
device is connected to the app.
7. Follow the instructions of the app and select the desired parameters.
8. Check and confirm the set values.
9. Press the ON/OFF switch
6
to switch it off.
The status indicator
5
is lit red and goes off as soon as the device has switched itself off.
The cleaning program has been configured and saved.
Switching off the device
Proceed as follows to switch off the device:
1. Lift the device out of the pool and switch it off.
2. Clean the filter unit and the device.
Stopping cleaning
The device stops cleaning automatically as soon as the rechargeable battery is almost discharged. The
status indicator
5
blinks yellow while the device moves to the pool wall and stays yellow as soon as it
has reached its end position.
Lifting the device out of the pool
1. Attach the hook
2
to a telescopic rod and
thread it into the handle of the device.
2. Slowly pull the device towards the water
surface until you can reach the handle.
3. Slowly lift the device out of the water and hold it
above the water surface.
After 10 to 15 seconds, most of the water that
has collected in the housing has drained back
into the pool.
4. Switch off the ON/OFF switch
6
.
The status indicator
5
is lit red and goes off as
soon as the device has switched itself off.
5. Set down the device next to the pool.
The device is lifted out of the pool.
8
25