Steinbach 061014, Original Owner'S Manual

Page: 23 / 230

General Information
Read and keep the operating instructions
These operating instructions are part of the "Pool Runner" pool cleaner (in the following also
called "device"). It contains important information about startup and operation.
Read the operating instructions and especially the safety instructions carefully before using
the device. Non-observance of these operating instructions can lead to severe injuries or
damage to the device.
Keep the operating instructions for further use. If you pass on the device to a third party, you must pass
on these operating instructions as well.
Intended use
This device is exclusively designed to keep private pools clean. The device is not suited for pools with
liners with a liner thickness of less than 0.4 mm.
This product is exclusively intended for private use and not suited for the commercial sector. Only use
the device as described in these operating instructions. Any other use is considered inappropriate and
may lead to material damage or even injury. The device is not a toy.
The manufacturer or retailer will not assume any liability for damage caused by inappropriate or
incorrect use.
Explanation of Symbols
The following symbols are used in these operating instructions, on the device or on the packaging.
Here you will find useful additional
information.
Risk of damage!
Do not open the packaging with sharp
or pointed objects, such as cutters
Safety
The following signal words are used in these operating instructions.
WARNING!
This signal symbol/word denotes a hazard with an average
risk level that could lead to death or severe injury if it is not
avoided.
CAUTION!
This signal symbol/word denotes a hazard with a low risk
level that could lead to mild or moderate injury if it is not
avoided.
NOTICE!
This signal word provides a warning about potential material
damage.
General safety instructions
WARNING!
Risk of electric shock!
Faulty electric installation or excess mains voltage can cause an electric shock.
-
Only connect the power cable if the mains voltage of the socket matches that on the type
plate.
-
Only connect the power cable to an easily accessible socket so that you can quickly
disconnect it in the case of a fault.
-
Only connect the power cable to a grounded socket.
-
Operate the device only at an outlet with a protective contact and a fuse with max. 16A.
23
en