Torch Runner (HS)
Torch Runner (HS) Operator’s Manual
10
The precise machine torch holder (Fig. 1a) allows torches with the handle diameter
of
35 mm
(1.38’’)
equipped
with
a rack. Loosen the lower handle to precisely set the
torch angle. Use the knob to adjust the vertical position of the torch.
The precise torch holder (Fig. 1b)
is designed for
torches
with
the
handle
diameter
of
28
–35 mm
(1.10
–1.38’’)
and allows precise adjustment of the torch angle. The knob
can be installed at either side after loosening the set screw and is used to adjust the
vertical position of the torch. To adjust the resistance of the vertical move, use the
2.5
mm
hex
wrench and
unscrew all fixing screws, and then use the
2
mm
hex
wrench
and
adjust
the
adjusting
screws.
Use the rack position knob to adjust the horizontal position of the
torch, and use
the rack locking levers to lock the rack in position.
Then,
connect
the
torch
to
a proper gas source. Depending on the cutting method
(oxy-fuel or plasma) install into the carriage slot either a gas manifold or the arc
ignition set in the manner described in the subsection of the respective accessory.
Position the carriage on the workpiece or track so that the torch is placed right
above
the
starting
point
of
the
cut.
Then,
set the clutch to ON.
3.2. Operating
Set the power swi
tch to ‘I’ to turn on the power, which will light all parts of the display
(
). Then, the
appears if the unit of speed is set to centimeters per minute, or
for inches per minute. Next, the carriage speed appears. The speed can be
changed
by
rotating the
knob on the panel. If needed, set the clutch to OFF and
travel the carriage manually.
To start the cutting, light the torch as described in the torch manual. Adhere to all
rules included in the torch manual.
Use the travel direction switch to select a direction of travel. Then, the real speed
of the carriage appears on the display.
To stop the travel,
set the
travel direction
switch to
‘O’ or the clutch to OFF. To extinguish the torch flame, proceed as
described in the torch manual.
After the work is finished, use the power switch to turn off the power and unplug
the
carriage
from
the
power
source.
Clean
the
teeth
of
the
rack
once
a week.
