14
MAINTENANCE
WARNING!
ALWAYS DISCONNECT THE SAW FROM POWER SOURCE BEFORE CHANGING BLADES
,
CLEARING CHIPS OR MAKING ADJUSTMENTS
.
CHANGING SAW BLADES
Refer to the diagram to the right.
1. Place saw on a level, secure surface.
2. Move the swivel guard (item #130) by
loosening the thumb screw (item #134)
and rotating it to expose the blade
retaining bolt.
3. Engage spindle lock (item# 46).
4. Using supplied hex wrench, loosen and
remove the blade drive mounting bolt,
washer and outer blade drive flange
(items# 136-139).
5. Move the blade guard up and out of the
way (item # 115).
6. Remove saw blade. (item 135)
7. Thoroughly clean inner and outer blade
drive flanges and blade mounting
surface before installing new blade.
8. Verify blade rotation is correct.
9. Reverse process to install new blade.
Thumb Screw
Blade Guard
Swivel Guard
Blade Flange
and Bolt
Metal Cutting
Saw Blade
Brush Holders
REPLACING MOTOR BRUSHES
Refer to the diagram to the right.
Motor End
Cover
1. Place saw on level, secure surface.
2. Tip saw on its right side (blade side down).
3. Remove two (2) motor end cover screws and remove
the cover and motor bearing spring washer.
4. Remove the two brush caps and slide brushes out.
Caution! Do not rotate brushes if re-installing. Note
exact position when re-installing brushes.
3. If the carbon rod is less than 6mm or if there are
signs of burning or other wear, replace the brushes.
4. Reverse the process to re-assemble saw.
Brush Cap
Bearing Spring
Clip
Motor Brush
(2)
Summary of Contents for S14
Page 9: ...9 24 141 141 ...
