D250X
This document is protected by copyrights.
Copying, using, or distributing without permission of PROMOTECH is prohibited.
9
3. STARTUP AND OPERATION
3.1. Installing and removing the annular cutter
Unplug the power cord and rotate the handles to the right (
1
) to lift the motor. Use
gloves to put the correct pilot pin into the annular cutter (
2
). Use a dry cloth to clean
the arbor and the cutter. Put the cutter into the arbor (
3
) to align the flat surfaces (
4
)
with the screws (
5
). Use the 5 mm hex wrench to tighten the screws.
To remove the cutter, loosen the screws (
5
) with the 5 mm hex wrench.
2
1
3
5
4
