BM-20 plus
BM-
20 plus Operator’s Manual
9
3. STARTUP AND OPERATION
3.1. Adjusting the bevel angle and width
Unplug the machine from the power source. Start with setting the bevel width to zero.
To do this, loosen two lock levers (Fig.
2), rotate the knob to set ‘0’ on the bevel width
scale, and tighten the levers.
Fig. 2.
Initial setting the bevel width to zero
To set the required bevel angle (Fig. 3), use the 6 mm hex wrench to loosen two side
screws. Rotate the guide set to get the required angle on the scale, and tighten the
screws in this new position.
