background image

Sync

 Height Adjustable Leg Wire Management

If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico, 
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com

©

 

2014 Steelcase Inc. 

Grand Rapids, MI 49501 
U.S.A.  
Printed in U.S.A.

®

Page 1 of 8

939549946 Rev G

This equipment has been tested and found to comply with the limits for a class B digital device pursuant
to Part 15 for FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the
separation between the equipment and receiver. • Connect the equipment into an outlet or a circuit different
from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician
for help.

This class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada

The power socket/outlet shall be installed near the equipment and shall be easily accessible.

SAVE THESE INSTRUCTIONS

OPERATING INSTRUCTIONS

 - 

Please refer to the attached Installation Instructions and the provided User Guide.

USER-MAINTENANCE INSTRUCTIONS

 - 

                         - 

DANGER

                           Do not modify the plug provided with the product - if it will not fit the outlet, have a proper outlet installed by a
qualified electrician.

                                                                     The receptacle power block is equipped with a circuit breaker that will shut
off power in an overload condition. Press to reset the circuit breaker to restore power.

SERVICING OF DOUBLE-INSULATED PRODUCTS - In a double-insulated product, two systems of insulation are provided
instead of grounding. No grounding means is provided on a double-insulated product, nor is a means for grounding to be added
to the product. Servicing a double-insulated product requires extreme care and knowledge of the system, and is to be done only
by qualifiedservice personnel. Replacement parts for a double-insulated product must be identical to the parts they replace. A
double-insulated product is marked with the words “DOUBLE INSULATION” or “DOUBLE INSULATED.” The symbol
(square within a square) is also able to be marked on the product. 

IMPORTANT SAFETY INSTRUCTIONS

When using an electrical furnishing, basic precautions should always be followed, including the following:
Read all instructions before using (this furnishing).

- To reduce the risk of electric shock:

DANGER

1.  Always unplug this furnishing from the electrical outlet before cleaning.
2.  Close supervision is necessary when this furnishing is used by, or near children, invalids, or disabled persons.
3.  Use this table only for its intended use as described in these instructions. Do not use attachments not 
     recommended by the manufacturer.
4.  Never operate this table if it has a damaged cord or plug, if it is not working properly, if it has been dropped or
     damaged, or dropped into water. If the cord is damaged have it replaced by a Steelcase dealer.
5.  Keep the cord away from heated surfaces.
6.  Never drop or insert any object into any opening.
7.  Do not use outdoors.
8.  Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
9. To disconnect, remove plug from outlet.
10.                         Do not use this table to support televisions.
11. Each surface intended to support a load shall have a corresponding statement in the use instructions specifying the
      maximum intended load for that surface.
12. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
      capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
      use of the appliance by a person responsible for their safety.
13. Children should be supervised to ensure that they do not play with the appliance.    

WARNING

Summary of Contents for Sync









Reviews: