Page 17 of 18
939564905 Rev E
®
1
When possible, the table should be moved in a horizontal (flat) position.
2
If the table must be turned vertically (i.e. standing on a pallet), care must be taken to ensure
no side pressure is placed on any of the lifting columns as it is tipped into position, during
transport, and when tipped off the pallet at the new location.
3
Before use in this location, the table must again be completely leveled side-to-side and front-to-back.
Failure to do so may cause binding of the lifting columns and failure to operate properly.
4
After moving, the lifting columns must be re-synchronized. Refer to prior page.
Guidelines on Moving the Table
WIRE MANAGEMENT
CABLEWAY
END CAP
END CAP
LEFT LIFTING
COLUMN
RIGHT LIFTING
COLUMN
WORKSURFACE
TOP
CONTROLLER
(CAN BE POSITIONED
ON LEFT OR RIGHT SIDE)