Steelcase
29
Preparing to use ēno
note:
NOTE:
Although it is not recommended, it is possible to use the host computer’s
built-in Bluetooth capability or a third-party Bluetooth product to pair with
the ēno stylus. Refer to “Appendix 1: ēno Bluetooth pairing options” on
page 83. The stylus is identified as device ADP-301.
ēno receiver LED status summary and troubleshooting
If the ēno receiver LED is green and…
•
Flashes five times after you attempted pairing, the stylus and the ēno
receiver have been successfully paired.
•
Flashes three times when you removed the stylus cap (after the stylus
has been paired and the ēno App 3.0 or higher is running), the ēno
stylus has successfully re-connected to your computer.
If the ēno receiver LED is blue and…
•
Is solid blue, the ēno App is communicating with the ēno receiver.
•
Is flashing as you use the stylus, data is streaming from the ēno stylus to
your computer successfully.
If the ēno receiver LED is red and…
•
Quickly flashes five times after you attempted pairing, the stylus and the
ēno receiver have not been successfully paired. You need to start the
pairing process over again.
•
Flashes three times when you removed the stylus cap (after the ēno
stylus has been paired and the ēno App 3.0 or higher is running), the
ēno stylus has not been successfully connected to your computer. You
need to cap and uncap the stylus again.
•
Is solid red, the ēno App is not updated to version 3.0 or higher, or the
driver is not running. Launch the ēno App version 3.0 or higher on the
host computer and start the pairing process over again.
