Steel City 55230, User Manual

Page: 19 / 36

19
INSTALLING THE
MOTOR DRUM GUARD
MAKE CERTAIN THE MACHINE IS DISCONNECTED
FROM THE POWER SOURCE.
WARNING
!
NOTE: The motor drum guard will have to be positioned
to the rear of the sander while the workpiece support or
the extension table is installed.
1. Place the motor drum guard (A) over the dust chute
(B).
SEE FIG. 9.
Fig. 9
2. Install three 3/16-24 x 1/4" screws (C) and tighten.
3. The edge sander is also equipped with a 4in.
dust port (D) that should be connected to a dust
collector.
INSTALLING THE FENCE
MAKE CERTAIN THE MACHINE IS DISCONNECTED
FROM THE POWER SOURCE.
WARNING
!
D
B
C
A
1. Slide the two T-nuts (A) into the miter slot (B) in the
main table.
SEE FIG. 10.
2. Place the fence (C) over top of the T-nuts.
3. Install one 5/16" flat washer on each of the lock
knobs (D), and thread the knobs into the T-nuts.
4. Position the fence in the desired location and tighten
the lock knobs.
Fig. 10
D
B A
C
D