Steel City 40630CH, User Manual

Page: 17 / 31

17
ASSEMBLY
MAKE CERTAIN THAT THE MACHINE IS DISCON-
NECTED FROM THE POWER SOURCE.
WARNING
!
LEG STAND ASSEMBLIES
1. Attach 2 stand legs (A) to the side panel (B) that
carries the logo. Using four of each carriage bolts (C),
SC80462, and flange hex nuts (D), SC82133, to
assemble the legs and front panel together. Tighten
the nuts finger tight.
SEE FIG. 1
2. Repeat the above step for the remaining legs and
side panel. Tighten the nuts finger tight.
3. Insert four carriage bolts (A), SC80462, through the
front and back leg & panel assembly. Assemble it
with the top (B) and down (C) support brackets on
one side, then attach flange hex nuts (A), SC82133,
to bolts. Tighten the nuts finger tight.
SEE FIG. 2 & FIG.
"#$ %' * "#
++;<= >? @#Z+ "#Z @[+ **?Z@<= % #?\]
4. Repeat the above step to attach leg & panel
assembly to the remaining top and down support
brackets.
5. Press the leveling pad (A) onto each leg, set the
stand upright and tighten all stand fasteners securely.
^_]
JOINTER & STAND ASSEMBLIES
NOTE: The jointer assembly is heavy and bulky. Two
people are required to lift the tool.
1. Carefully place the jointer onto the stand, making sure
the holes in the jointer feet (A) aligns with the holes
(B) in the stand.
SEE FIG. 6
^Z`] 1
J
^Z`] 2
^Z`]
^Z`]
A
D
C
B
B
A
A
A