13
ADJUSTMENTS
1.
2.
3.
4.
For safety, unplug from power source (FIG.4(C)), remove yellow key from under the red paddle (FIG4(D)).
To raise or lower the infeed table, make sure the tables coplanar and that the pointer is at zero (FIG.4(A)). If beds are
level and pointer is off, loosen the 2 small screws (FIG.4(E)) to shift the pointer to 0.
If you need to adjust, release the lock knob (FIG.5(A)) by turning counter clockwise.
Grab the infeed handle (FIG.4(B)) and turn clockwise to raise and counter clockwise to lower.
A. Maximum removal is 1/8”
B. Lock the bed knob (FIG.5(A))
1.
2.
3.
4.
FIG.6 (A) is the lock knob, turn counter clockwise to move the
fence body (FIG.6 (E)) forward or backwards.
FIG.6 (B) is the positive stop adjustment for 45°/135°. Release
handle (FIG.6 (D)) to be able to tilt the fence backwards.
FIG.6 (C) is adjustment for 90° and the positive stop as well. Flip
out of the way to allow fence to tilt.
When adjustments are complete, tighted (FIG.6 (A & D)).
The granite fence on your jointer can be positioned 45°, 90°,135°.
INFEED TABLE ADJUSTMENT
ADJUSTING FENCE POSITIVE STOPS
FIG.4
FIG.5
C
B
A
E
D
A
B
FIG.6
A
D
B
C
E