XP-NightHawk Device Set Up
In order to setup the transmitter and headset, you will find set-up instructions
included in the packaging.
Before set-up, please charge your headset by plugging the Micro USB into the
headset and the other end into an available USB port on your device. A little
LED will light (situated on the base of the headset) solid RED to indicate
charging, after around 4-5 hours the RED LED light will turn off to indicate the
headset is fully charged and ready for use.
Once the transmitter and headset has been set up on your chosen format,
please find below instructions on how to set up your new gaming headset
within your device.
Once your all connected with the headset and transmitter, Please follow the
below:
1.
Power on the headset by holding the Power Button.
(The headset and transmitter LED’s will begin to flash BLUE)
2.
Press the Pair button. The LED’s on both the headset and the transmitter
will light solid BLUE to signal the headset has been paired with your
device.
If you are experiencing problems setting this up on your console, please do
not hesitate to contact one of our friendly team.
PLAYSTATION 4
After you have powered the PS4 console one, go to…
SETTINGS
>
SOUND
and
SCREEN
>
AUDIO OUTPUT SETTINGS
>
PRIMARY OUT
PORT
>
DIGITAL OUT (OPTICAL)
>
Remove the tick from DOLBY DIGITAL 5.1ch
and DTS 5.1ch.
Then please go to the following:
1.
AUDIO OUTPUT SETTINGS
>
AUDIO FORMAT(PRIORITY)
>
“SELECT
LINER PCM”
