www.stealthtronic.com | [email protected]
user manual
Glite PRO
1.
Insert the Nano-SIMcard and wait for about 10 seconds for the device to bootup
2.
Call the unit, and the unit will pick up the call
3
. Wait for unit to send replies, sometimes it can take a short amount of time.
4.
Close the unit with screwdriver, gently tighten
Activation of VOX
detection
SNDSENS
0 -OFF
1-100 – The lowest sensitivity
The number re
fl
ects the “dB” in the surrounding,
so if you will set it to 30 you will need noise of 30
dB to activate it. Recommend it for activation by
voice is 30-50db
Movement detection
MOVESENS
0 -OFF
1 - MOST SENSITIVE
100 - the lowest sensitivity
The number re
fl
ects a vibration in a sensor that
needs happen, before the unit is activated.
Factory settings
RESET
Factory settings = SLP0, SLPINT15, PWRINT2,
LEDMSK15, MOVESENS0, SNDSENS0
Status of device
STATUS
Returns the status of the device, including a
battery
Password settings
PASSWORD
0 – Turn off
001 - 999 – set number
possibility
If you decide to activate password you will have to
use it for further communication with the device.
For example, if you set PASSWORD777 and you
will want to change the sensitivity you will need
to do so like this 777SNDSENS50
Turn off LED diodes
LEDMSK
0 – OFF
15- ON
You will turn off the led diodes by sending to the
device LEDMSK0
Voice during phone
call (Gain)
Simply, for increasing the signal from the micro-
phone, you use following commands, pressing on
the keypad: #01, #02, to #09 … wait in between the
pressing of DTMF tone.
Commands:
- variable
Start up
Glite Vario PRO
Glite 20 PRO