FAQ
(English)
My SQuape X is leaking or has got
some drops between the tank and
base.
Cotton must be placed in front of the liquid
holes and the channels. Use the supplied hex
wrench to place the cotton into the right
position. For liquids with lower VG
percentage use a little more cotton and push
it a bit more to the liquid holes and channels.
Do not press, but to make sure it sits well. It
is extremely important that no cotton is on
the deck ledge. Use a good amount of cotton
to fill the deck. For example, it helps to place
cotton in the middle of the deck to build a
bridge between the two coils. We
recommend to change the cotton
periodically. Certain cotton varieties can
collapse and then no longer store the liquid
sufficiently.
I get dry hits
The cotton was probably pressed too firmly
to the liquid holes and the channels within
the deck. Either loosen the cotton slightly or
lay new cotton.
The wire is cut when assembling
Soft wires, like NI200 or NiFe and thin wires
<0.3mm could be cut by excessive
tightening. Place the wire in the hole
(centrally) and tighten gently with the hex
wrench in the grub screw. Insert the hex
wrench with the long side so you apply less
force.
No contact to the mod, „no
atomizer »
Unscrew the centerpin a little. If this does not
help, contact
How to clean the SQuape X
There is a need from time to time to unscrew
the centerpin and wipe it with a cloth.
Condensed water can work its way down to
the centerpin despite the sealing protection.
We recommend to clean the SQuape X with
running water or in an ultrasonic bath. Never
clean in a dishwasher.
The TopCap can not be closed
properly
Remove the tank from the base, use a 4mm
hex wrench, insert from below into the
chimney and tighten it. Then the TopCap will
close all the way.
