PROsine 2.5/3.0 Advanced Control System (ACS) Owner’s Manual
11
3. Installation
The ACS Panel should be installed in a location that is most convenient for you
so the important display and control information is easily accessible.
To connect the Control Panel
1.
Decide on the location of choice for the ACS Panel. For flush mount
installation onto a wall, the remote panel requires an opening with the
measurements of 4 1/8 inches by 4 1/8 inches (10.5cm by 10.5cm). Ensure
there is no wiring or other obstruction within the wall before making this
opening as the ACS Panel requires approximately 2 inches (5cm) of free
space within the wall to accommodate its depth.
2.
Connect the supplied cable to the ACS panel and route the cable back through
the wall opening and back to the PROsine unit. Keep the EMI bead (large
yellow bulb on cable) close to the PROsine unit and don’t plug the cable in
with the EMI bead closer to the ACS Panel (it is far more effective close to
the base chassis). Connect the cable to the REMOTE output connector jack
found on the side of the PROsine itself (the panel can be connected to either
output).
3.
If you purchased the ACS Panel as an accessory to be used with your
PROsine 2.5, the ACS Panel and standard supplied panel can both be used at
the same time. Either connect the standard panel to the OUTPUT jack on the
back of the ACS Panel, or connect the standard panel to the REMOTE output
connector jack on the side of the PROsine Inverter•Charger. The standard
panel can then be mounted close by the PROsine unit for system monitoring
in that location and the ACS Panel can be mounted remotely in some other
area where you want the more detailed operating information and control
capability.
Summary of Contents for Prosine 2.5
Page 2: ......