31
www.starwincom.com
Tel: +8629-88664381, E-mail: [email protected]
Figure 5-
2-2-11
Signal Quality Display
5.2.3
Terminal Alignment
Other Function introduction
(1)
Beam Switch
Press and hold the sub key to enter the sub interface. If it is not in the beam switching interface, continue
to press the sub key to switch to the beam switching interface. At the same time, press and hold the main
and sub keys to send the beam switching command, as shown in Figure 5-2-3-1 and Figure 5-2-3-2.
Figure 5-
2-3-1
Beam Switch Start
Figure 5-
2-3-2
Beam Switch Success
(2)
BUC Control:
a.
There are two infrared keys on the right side of OLED screen, which are arranged vertically. The
upper key is the main key to control the main interface, and the lower key is the sub key to control
the sub interface.
b.
The switch between the main and sub interfaces is realized by press and hold the corresponding
key, that is, press and hold the main key can switch from the sub interface to the main interface, or
switch in each sub interface of the main interface, and press and hold the sub key can switch from
the main interface to the sub interface, or switch in each sub interface of the sub interface.
c.
The function of sub interface (such as BUC on/off) is realized by pressing the main and sub keys at
