StarTrac 263-4WD-8G-STAGE-V, Owner'S Manual

Page: 71 / 100

71 | P a g e
OWNER’S MANUAL | STARTRAC 263 4WD – 8G – STAGE – V
5.37 CLUTCH PEDAL
•
Check the free travel of the gearshift clutch pedal at
suitable intervals.
•
Excessive play reduces the disengaging travel of the
clutch and could prevent the gears from being correctly
meshed.
•
On the other hand, insufficiently play could lead to
abnormal wear on disengaging thrust bearing,
overheating and rapid wear on the clutch itself.
•
Do not keep foot on clutch pedal while tractor is in
running condition. It may cause excessive wear of clutch
and clutch falls before its lifetime.
5.38 METHOD TO CHECK CLUTCH PEDAL FREE
PLAY
•
Press down the clutch pedal and measure the free play of
pedal as shown in the figure (Fig. 5-11).
•
The distance should be 25 to 30 mm.
•
If the distance is less than 25 mm or higher than 30 mm
then get it adjusted
5.39 METHOD TO ADJUST CLUTCH PEDAL FREE PLAY
•
Loosen the Fork and check nut (1)
•
To restore the pedal travel 'A"
•
Then fit the Fork back again and lock the Check nut.
5.40 BRAKE PEDAL
•
Use independent brake in the field operations.
•
In field you will turn more sharply by pressing brake pedal
for the side wheel on the turn.
•
The pedals must be locked for road use.
5.41 METHOD TO CHECK BRAKE PEDAL FREE
PLAY
•
Release the hand brake. Uncouple the two pedals.
•
Press down the right-hand pedal and measure the free
play of pedal as shown in the figure.
•
The distance should be between 35-40 mm.
•
If the free play is less than 35 mm or higher than 40 mm then adjust the both hex nut on
actuator tie rod until free play comes to 35 to 40 mm.
•
Now, press down the left-hand pedal, If the values are not equal with the right-hand pedal,
then repeat the same procedure until values come equal.
Fig.5.25
Fig.5.26
Fig.5.27