24 |
P a g e
OWNER’S
MANUAL
|
STARTRAC 263 4WD
–
8G
–
STAGE
–
V
Comply with the following procedure if it is essential to fold
down the protective structure for the above reasons:
1.
Remove the fixing pins (2).
2.
Lower the protective structure (1) slowly until it rests on the
stopper. Be careful do not injured yourself.
3.
Fit the fixing pins (2) and relative nuts as illustrated.
4.
Before you use the tractor again in any way, set the
protective structure (1) back in the upright position (Fig. 2.1)
by carrying out the operation described above in reverse
order. Fit the fixing pins.
•
To avoid loosening of structure the protection offered by
the safety structure will be impaired if it is subjected to
structural damage, as in an overturn accident, or is in
anyway altered by welding, bending, drilling or cutting.
•
A damaged safety structure should be replaced, NOT reused.
•
Always keep upper part of the safety structure pinned in vertical position (as in the above
Fig.2.1) when operating the tractor.
•
If the tractor is operated with the safety structure folded down (e.g. to enter a low building)
drive with extreme caution and DO NOT use seat belt.
•
Fold the safety structure up again as soon as the tractor is operated under normal
conditions.
2.16
OPERATION
:
Before using the tractor ensure that the safety frame is not
damaged, that it is securely fastened to the tractor, and, if a hinged
section is fitted, that it is in the raised position and secured.
If
the safety frame has been removed from the tractor, or folded
down for a specific operation, it must be refitted or erected
immediately using the proper hardware and applying the
recommended torque value.
DO NOT ATTACH chains, ropes or cables to the safety frame for
pulling purposes; this will cause the tractor to tip backwards. Always pull from the tractor
drawbar.
If a seat belt is installed, always wear your seat belt-adjusted snugly except when operating with
a folded down safety frame or if the safety frame has been removed.
Check the seat belt for damage. A damaged seat belt must be replaced.
1
2
Fig.2.2
Fig.2.3
Summary of Contents for 263-4WD-8G-STAGE-V
