Quick-Start Guide
To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support.
Manual Revision: November 11, 2020
Secure Articulating Universal Tablet Mount
• (Optional -- for mounting) Electric Drill
• (Optional -- for mounting) Writing Utensil (i.e. Pencil, Pen, etc.)
• Phillips Head Screwdriver
Installation
Configure the Tablet Holder
1. Pull and hold the top
Tab
and extend the top
Tablet Holder Arm
until it reaches its
full length.
(Figure 1)
2. Fold out the two lower
Tablet Holder Arms
.
3. (Optional -- for thin
Tablets
) Peel and stick the three
Spacers
over the existing
Screen Protection Pads
located within the tips of all three
Tablet Holder Arms
.
Install the Tablet Holder
1. While the
Table Holder Arm (Top)
is fully extended, align the hole in the
Tablet
Holder
with the
Pivot Point
on the
Tablet Stand
. Continue to hold the
Tablet
Holder
.
(Figure 2)
Washer
Product Diagram (SECTBLTDT)
Rear View
Component
Function
1
Tablet Holder
• Holds a single
Tablet
• Allows for 360
°
of rotation
2
Lock Slot x 2
• Deters theft
• Insert (up to) two
K-Slot Style Laptop Locks
(one
included, one sold separately)
3
Tablet Holder Arm
• Part of the
Tablet Holder
• Three points of contact with the
Tablet
• Integrated
Spacers
to prevent Tablet scratches
• (Optional)
Spacers
can be inserted into the
Tablet
Holder Arms
for thin
Tablets
4
Tablet Stand
• Holds the
Tablet Holder
• Allows for 180
°
of tilt
5
Cable Management
Holes
• Route the
Tablet
Charging Cable
and
K-Slot
Style Laptop Lock Cables
through the
Tablet
Stand
Requirements
For the latest requirements, please visit:
www.startech.com/SECTBLTDT
• Tablet
• Size: 7.9 - 13 Inch (200.66 - 330.2 mm)
• Thickness (Maximum): 0.374 Inches (9.5 mm)
*Tablet sold separately.
1
4
2
3
5
Figure 1
Tab
(Top)
Tablet Holder Arm
(Top)
Figure 3
Figure 4
Tablet Holder
Arm (Bottom)
Tab
(Bottom)
Figure 2
Upper Hole
M4 Screw
Lower Hole
Pivot Point
