Instruction manual
13
Convert the ARMSTS to a sitting or standing position
1. To convert the ARMSTS to a standing or sitting position, press the lever on the
pneumatic arm.
2. To adjust the tension, move the arm to 45 degrees and do one of the following:
• If the weight of the monitor(s) makes it difficult to easily lift the workstation,
use the M6*95 Allen wrench (
11
) to move the screw at the back of the
pneumatic arm (
1
) counterclockwise.
• If the workstation lowers too quickly, use the M6*95 Allen wrench (
11
) to
move the screw at the back of the pneumatic arm (
1
) counterclockwise.
• If the workstation doesn’t easily lower down, use the M6*95 Allen wrench (
11
)
to move the screw at the back of the pneumatic arm (
1
) clockwise.
11
1