Start italiana Digimon TFT, Installation Manual

Page: 10 / 24

Digimon TFT rev.01 2014/05 - ENG
10
CHANNELS
Here you can select the tank from 1 to 32 of the console
SYSTEM CONFIGURATION
Console configuration section:
TOTAL CHANNEL
set total number of probes conneted to the console.
TOTAL SLAVE
set total number of slave configured in the console es: Display Digimon slave bordo macchina.
HISTORY INTERVAL (min)
time elapsed used to store history measurements on Micro SD (if present)
PROTOCOL TYPE
select output comunication protocol on serial port RS232 of the console to connect the console to
managment systems (GILBARCO, TOHKEIM, NUOVO PIGNONE, TOPLEVEL)
DELIVERY TIMES (S)
WRITE CONFIGURATION
Button to save the above information to the console.
STRAPPING TABLE
The console has the facility to calculate the volume starting from the height as linear
interpolation between two near points. In order to do that operation the strapping table
(correspondence mm – lt) must be downloaded into the console.
It is necessary to follow few rules in order to download correctly the table into the console:
 Values in millimeters/inches and liters/gallons
 Maximum number of points: 250
 Numbers with decimals have to be written with a dot ( . ) and not with a comma.
 Table has to be written in Excel or Note Pad and saved as .csv or .txt.
The .csv format allows to save the data filled into the Excel table separating them with semicolon symbol ( ; ).
Opening .csv file with Note Pad it will be possible to read data as per the example shown below. Otherwise it is possible to complete the
table manually into program Note Pad separating the values with semicolons.
DIGIMON FUCNTIONS
Following all the Digimon available functions, tank data, diagnostic data, graphical an stock percentage. Arrow are used to navigate
through all the tanks connected and all the functions.