background image

M A K E   A   G R A N D   E N T R A N C E

I N S TA L L AT I O N  

 

G U I D E

S E R I E S   S - 7 0 0

If you think anything is missing, or  
there is damage, alert Spitfire Doors  
or your supplier immediately. 
[email protected]

1.

  If you are replacing an existing door, please measure 

the new door to make sure it fits before removing 
the old door and make sure that the threshold height 
and or cill and packers allow enough clearance to 
open the new door when fitted.

2.

  Please store your new door in a clean and obstacle 

free area before installing

3. 

Make sure the aperture is level and as plumb as 
possible before starting to install

4.

 

REMEMBER – A SINGLE S-700 SERIES DOOR 
WILL WEIGH AT LEAST 120KG AND IS A 
MULTIPLE PERSON LIFT!

Key Points:

We recommend that your door is  
installed by a recognised Spitfire Partner.

Summary of Contents for S-700 Series

Page 1: ... fits before removing the old door and make sure that the threshold height and or cill and packers allow enough clearance to open the new door when fitted 2 Please store your new door in a clean and obstacle free area before installing 3 Make sure the aperture is level and as plumb as possible before starting to install 4 REMEMBER A SINGLE S 700 SERIES DOOR WILL WEIGH AT LEAST 120KG AND IS A MULTI...

Page 2: ...n whilst adjusting during installation Carefully unwrap your S 700 pivot door and dispose of the timber sub frame It would be a good idea to protect your door with a blanket or dust sheet prior to installing as conditions on site are seldom perfect Keep your door and all components away from hazardous materials like lime cement or paint Cleaning door after installation Surfaces should be only clea...

Page 3: ...uare then check vertical is plumb and fix the brackets to the adjoining walling As a general rule we recommend fixing 150mm in from each corner and then at 400mm intervals Please peel back the frame gaskets and fix behind them We suggest you remove the lock keep and fix behind the keep Please always fix your door through the frame and do not use fixing brackets On the threshold remove the rubber c...

Page 4: ... with the levelling screw that is located on the pivot side of the sash underneath the gasket You will need to insert an extra long flat head screw driver into the side of the door sash to reach this screw Image 7 PLEASE BE AWARE You MUST remove unwind the top pin and tilt the sash onto its side when making the levelling adjustment Otherwise the full weight of the sash will have to be moved by the...

Reviews: