www.starlink7.com
Copyright © 2018 StarLink LLC. All Rights Reserved.
Specifications are subject to change without notice. Please contact your sales representative for further information.
Ethernet-Over-Coax (EoC) Adapter with TV and Wi-Fi Extension
■
①
Locate the coaxial outlet in room desired to place AN2015(W) Adapter. Another
AN2015(W) Adapter is needed to be connected at the other end of the coaxial outlet
by following the same procedure from step 1 to step 7.
②
Connect the end of a coaxial cable into the coaxial port labeled ‘CABLE IN’ on the
side of the AN2015(W) Adapter.
③
Connect the other end of the coaxial cable installed in step 2 to the wall outlet.
④
Optionally
, if wired Ethernet connection is needed, connect the end of the Ethernet
cable into the Ethernet port ‘1’ on the side of the AN2015(W) Adapter. Connect the
other end of the Ethernet cable into the Ethernet port of a computer.
⑤
Plug in the power adapter into the ‘Power’ port on the side of the AN2015(W)
Adapter. Plug the other end of the power adapter into an electrical outlet or power
supply.
⑥
Wait till the ‘CABLE’ and ‘Wi-Fi’ (AN2015W only) LEDs on the front panel glow green
for AN2015(W) to get ready.
⑦
If AN2015W is used, read the label on the its side for 2.4GHz SSIDs and WPA
key/password. Default SSID and WPA key can be changed by going through Web
configuration user interface.
AN2015W EoC Adapter with Wi-Fi Extension
Boost the speed and performance of home networking to reach more than
1 Gbps over new generation of EoC technology
Configurable high-frequency modulation (1.1GHz to 1.6GHz) allows Cable TV
(DOCSIS 3.0/3.1), Satellite TV and other TV signal overlay without interference
Turn any coaxial outlet to high-speed Ethernet / IP connection with optional
Wi-Fi extention for high-definition video streaming, and high-speed Internet
Supplement and extend the existing Wi-Fi network with high-speed wired
connection over in-home coaxial drops
Enable tablets, smart phones, gaming APPs/consoles and 4K/8K HDTV to
access content simultaneously
Work over the existing home coaxial wirings without re-wiring of Ethernet
cables
Plug-and-play installation to deliver both high-definition TV content and
high-speed data to every room inside home
Enhance Wi-Fi network over coaxial wirings to reach wired speed and
coverage reliability to offload Wi-Fi gateway/router for content transfer
between smart devices
Support IPv4 / IPv6, TR069, DHCP and console configuration
AN2015W / AN2015
■
■
■
■
■
■
■
Connecting the AN2015(W) Adapters without TV Signals
AN2015W Web Based Configuration
AN2015W can be configured from a Web browser
after joining its Wi-Fi SSID or connecting to its
Ethernet port from any smart device or computer
to login.
Refer to the user’s guide of AN2015W for details
to change
Wireless Settings
SSID, Radio Band, Wi-Fi Mode, Channel Bandwidth
Wireless Security
Security Mode, Pass Phrase/Password, Renew Cycle
Network Settings
Host Name, IP Settings, DHCP, DNS
Advanced Settings
Beacon Rate, Tx Power, Tx Burst
Wi-Fi Protected Settings (WPS)
■
Using splitter or tap to
connect multiple devices
to the same coaxial outlet
to share the signal
AN2015 EoC Adapter
