Starling Technologies Pocket Spin Drift Instruction Manual Download Page 1

                        

                                                

             

www.starling-tech.com

                                            

                      

          

Instruction Manual

Warning : Protect Board from electrostatic discharge. Ground yourself before handling.
Protect bottom of board from shorting against anything metal.

             

 

    Read Entire Manual Before Starting Your Project.

 Thank you for purchasing the 

Pocket Spin Drift

 lighting kit

 

from

 

Starling 

Technologies™.    

  

  From the 1960's Irwin Allen Hit Series “ Land of the Giants,” we've produced a 

Plug-N-Play light kit for the Moebius Pocket Spindrift. 
  Our highly efficient Light kit features pulsing Intake, as seen in the show, engine and interior
lighting, all running off a single CR2032 or CR2025 button cell battery. Runs continuously for 
hours with our low power circuit. 

Kit features our “No Show” switch design, no external wires or switches, kit uses a magnet 
with reed switch to power-on, allowing you to handle the model without a stand.

Built In The U.S.A 

with top quality components for longevity and long lasting battery life.

Kit Includes:

1x

 Fully assembled Plug-N-Play Pocket Spindrift board and lighting kit.

With red LEDs soldered to board, with wired reed switch and 2032 battery socket.

1x

 white LED light panel to illuminate interior of ship.

1x

 1/4” magnet

1

 PDF manual emailed after purchase.

1

Summary of Contents for Pocket Spin Drift








Reviews: