StarLab Microcentrifuge 24, Original Instruction

Page: 26 / 124

26
· Microcentrifuge 24 · Manual
6.5 Replacing fuses
The fuse holder is located under the mains power socket.
1. Disconnect the mains/power plug.
2. Open the fuse holder.
3. Replace faulty fuses and reinsert the fuse holder.
6.6 Decontamination before shipment
Please contact us before shipping a device.
If you are shipping the device to the authorized Technical Service for repairs or to your authorized dealer for disposal please note the following:
WARNING! Risk to health from contaminated device.
1. Observe the information on the decontamination certificate. It is available as a PDF document on our webpage
(www.starlab.click/decontamination).
2. Decontaminate all the parts you are going to dispatch.
3. Include the fully completed decontamination certificate in the shipment.
7 Troubleshooting
If you are unable to resolve the error with the suggested measures, please contact your local sales representative.
7.1 General errors
Problem Cause Solution
No display. No mains/power connection.  Check the mains/power connection.
Mains/power outage.  Check the fuse of the device.
 Check the mains/power fuse of the lab.
Centrifuge lid The rotor is still running.  Wait for the rotor to stop.
cannot be opened.
Mains/power outage. 1. Check the fuse of the device.
2. Check the mains/power fuse of the lab.
3. Actuate the emergency lid release.
Centrifuge cannot The centrifuge lid is not closed.  Close the centrifuge lid.
be started.
Centrifuge shakes The rotor is loaded asymmetrically. 1. Stop the centrifuge and load the rotor
when it starts up. symmetrically.
2. Restart the centrifuge.
Maintenance
Microcentrifuge 24