BeiJing Starfire Control Technology Co.,Ltd
WeChat:18901200180
QQ: 1908817881
16
Cutting mode [G] : press the keyboard key
to switch the cutting mode between flame, plasma and
demonstration.
Cutting speed [F] : press the keyboard key
, change the value to change the cutting speed, and
press enter to confirm.
Manual speed [X] : press the keyboard key
, change the value to change the cutting
speed, and press enter to confirm.
Slot [N] : press the keyboard key
, change the value, change the slot size, and press enter
to confirm.
Preheating delay [T] : press the keyboard key
, change the value behind to change the preheating
delay, and press enter to confirm.
3.2.2 press the space on the main interface to enter the processing interface
：
The blank space key
[F1] fallback: the cutting nozzle returns along the original path (at this time, only a blank line is left without cutting);
[F2] advance: the cutting nozzle advances along the cutting path (only blank line, no cutting);
[F3] return parameter: the cutting nozzle returns to the starting point, that is, the starting point of the current
workpiece;
[F4] select perforation point: after selecting the perforation point, the cutter will automatically move to the selected
perforation point.
[F5] graphic amplification: enlarge graphics;
[F6] increase delay: increase the preheating time by 15 seconds at a time.
[F7] reduce the delay: reduce the preheating time, skip the remaining preheating time, note: the system does not
remember the preheating time.
3.2.3 start processing
