MR2-B31BP Series User Manual
2
Front and rear view
3. Hardware Requirements and Precautions
1. After the hard disk is formatted, the actual total capacity of the MR2 detected by the computer
operating system will vary from the sum of all hard disk capacities stated by the manufacturer.
2. To prevent data loss, do not remove MR2 while the system is running.
3. Please always connect the USB cable to the computer to ensure the energy saving function
operating normally.
4. Once the system has been initialized, do not switch hard disks around during use. Doing so may
prevent the RAID from being recognized by the system.
5. Once RAID mode has been set up, the switching of hard drives will lead to the removal of data
from the hard disks. Please be sure to backup the data on the hard disk before making any
switches.
6. Before switching the RAID mode, you need to switch to JBOD before adjusting to the required
mode.
7. The product needs to be restarted after adding or changing the RAID mode, and the update is
guaranteed to be the new RAID mode.
8. If the MR2 needs to be shut down or disconnected, please ensure the HDD is safely removed
through your operating system before turning off the power.
9. We strongly recommend backing up important data stored on the MR2 to another storage device
or a remote site. STARDOM will not be held liable for the damage or loss of data you stored on
the MR2.
Front View
NOTE:
Please make sure that the product is connected to the host (power on status) before turning
on the power, otherwise the product will be on the sleep mode.
C
B
A
I
DC / 5V / 3A
USB-C
RESET
DC
USB
Power Select
E
F
D
G
J
H
HDD access light
A
HDD enclosure pin release
B
HDD enclosure handle
C
Fan
D
RESET hole
E
USB 3.2 Gen2 Type-C port
(10Gbps)
F
RAID switch
G
Fan speed switch
H
I
USB Type-C for DC Input
(DC input 5V/3A)
J
Power select switch
Rear View
