Starck Sefam S.Box Duo S, Patient Manual

Page: 9 / 40

S.Box Duo S and S.Box Duo ST Installation  9
Installation
Standard installation of the device
The apparatus must be positioned on a flat and stable surface. It comes with a pre-mounted side cover
and according to the chosen configuration, it can also be delivered with a heated humidifier that
replaces the pre-mounted side cover.
1. If you have a humidifier or/and a communicating
accessory, remove the side cover from the device:
Press the button to unlock the cover (mark 4 in Figure 1)
and at the same time, pull the cover with the integrated
handle located under the cover away from the machine.
2. Install the communicating accessory (S.Box modem, S.Box Wi-Fi module or PolyLink system)
into the accessory slot (mark 10 in Figure 4) – we herefor refer to the corresponding instructions
in the installation and usage procedure.
3. Then place the cover on the rails in the side part of the device and push it against the device until
you hear a "click".
or
Install the heated humidifier (if included):
A)
Place the heater plate on the rails in the side part of the
device and push it towards the machine.
B) Lock the heater plate by pushing the latch to the left
as indicated by .
C) Place the base of the humidifier chamber on the heater
plate and push the humidifier chamber against the
device until you hear a "click".
WARNING:
If the heated humidifier is not properly installed, there is a risk of air loss which can cause a variation of the
applied pressure versus the prescribed pressure.