Remove the screws
2-4. Attaching the brand seal
Place the brand seal that was supplied over the
existing brand seal. (The characters on the operation
panel will be inverted when the printer is attached
to a wall or onto a stand.)
2-5. Attaching the holder plate
1
Remove the two screws from the printer as shown
in the illustration.
2
Attach the holding plate to the printer. Then tighten
the four M3 screws that were supplied to secure it
in place.
The screws fitted with flat washers are used where
the screws were previously removed.
2-6. Setting the printer on the stand
Insert the two hooks on the holding plate through
the two holes on the stand. Three different positions
are available for insertion. Select the position you
require.
Once the hooks have been inserted into the holes,
secure the printer on the stand using the two screws.
2-7. Setting the roll paper in place
1
Push the cover open lever, and open the printer cover.
2
Insert the roll paper as shown.
80871191 VS-T700
fig.6 Setting the printer on the stand
fig.7 Setting the roll paper in place
fig.5 Attaching the holder plate
fig.4 Attaching the brand seal
