―――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――
STAR Line Mode Command Specifications
3-43
3.3.11. Cutter
Control
ESC d n
[Name] Auto-cutter
[Code]
ASCII ESC d
n
Hex.
1B
64
n
Decimal 27
100
n
[Defined Area]
0
≤
d
≤
3
48
≤
d
≤
51 (”0”
≤
d
≤
”3”)
[Initial Value]
- - -
[Function]
Executes the auto-cutter.
After auto-cutter is executed, the printer considers that to be the top of the page.
n Auto
cutter
0, 48
Full cut at the current position.
Print data in line buffer is printed before a full cut.
This command is ignored if the printer is not equipped with an auto-cutter.
1, 49
Partial cut at the current position.
Print data in line buffer is printed before a partial cut.
This command is ignored if the printer is not equipped with an auto-cutter.
2, 50
Paper is fed to cutting position, then a full cut.
Print data in line buffer is printed before the operation described above.
This command is ignored if the printer is not equipped with an auto-cutter.
3, 51
Paper is fed to cutting position, then a partial cut.
Print data in line buffer is printed before the operation described above.
This command is ignored if the printer is not equipped with an auto-cutter.
(*) The auto-cutter function operates in the following ways on models that only have a full cut or a
partial cut.
• Models that perform only a full cut. Executes a full cut when there are
instructions calling for a partial cut.
• Models that perform only a partial cut.
Executes a partial cut when there are for instructions
calling for a full cut.
(*) When connected with a presenter, executes a full cut when instructed for a partial cut.