14
Removing the collected water
There are two ways to remove collected water.
1. Use the bucket
•
When the unit is o,if the bucket is full, the unit will beep 8 times and the Full
indicator light will flash, the digital display shows P2.
•
When the unit is on,if the bucket is full, the compressor turns off and the fan
turns off after 30 seconds for drying the water of the condenser, then the unit
will beep 8 times and the Full indicator light will -ash, the digital display shows
P2.
•
Slowly pull out the bucket. Grip the left and right handles securely, and
carefully pull out straight so water does not spill. Do not put the tank on
the -oor because the bottom of the bucket is uneven. Otherwise the bucket will
fall and cause the water to spill.
•
Throw away the water and replace the bucket. The bucket must be in place
and securely seated for the dehumidifier to operate.
•
The machine will re-start when the bucket is restored in its correct position.
NOTES:
•
When you remove the bucket, do not touch any parts inside of the unit. Doing
so may damage the product. Be sure to push the bucket gently all the way into
the unit.
•
Banging the bucket against anything or failing to push it in securely may cause
the unit not to operate.
•
When you remove the bucket,if there is some water in the unit you must dry it .
