Stannah GOODSMASTER CD, User Handbook Manual

Page: 11 / 20

11
C D - F E AT U R E S & O P E R AT I O N
CALLING/SENDING
Push button automatic lift controls are located at the
landing entrance, push and hold for two seconds to
operate.
To send the car to the required destination, either push the
arrowed/numbered button corresponding to the travel
direction required.
To call the car, push the arrowed/numbered button
corresponding to the travel direction required.
Buzzer for doors not closed
Buzzer for doors not closed Buzzer for doors not closed
Buzzer for doors not closed
The goods lift will only operate if all landing door and car
gates are closed. If a door/gate is left open, a continuous
buzzer will sound when a call/send push button is pressed,
except at the floor where the door/gate is open.
Check all gates and landing doors are shut and the lift should operate as normal.
Emergency stop button Emergency stop button Emergency stop button Emergency stop button
On each push button panel there is a emergency stop button. This should never be pressed
except in the case of emergency.
LOAD WEIGHING / EXCESS LOADS
A load weighing device is fitted to the lift. A buzzer will sound intermittently when the rated
load amount is exceeded within the lift car. The buzzer will continue to sound, to operate
the lift remove some of the load until the buzzer stops and the lift will reset automatically.
NOTE: The lift will not operate whilst the buzzer sounds and the rated load has been
exceeded.
Stop button
to
immediately
stop lift
operation
Push button
to call the lift
to that
landing