Stanley SCSS-700, Installation & Operation Manual

Page: 149 / 258

Programming
53722 9-1
Section 9
Programming
This section of the manual describes how to manually program the control panel from the
built-in annunciator. Each subsection discusses these menu options in detail. All options
described in this section can be performed using the Software Suite (SCSS-700PK).
9.1 UL 864 Programming Requirements
Important!
Before any customized programming is done, JumpStart AutoProgramming should be
run first. After JumpStart is run, thoroughly test the system. The reason the system
should be tested after JumpStart AutoProgramming is because Jumpstart
AutoProgramming automatically programs the system, searching for and configuring
all SLC and SBUS devices it finds. JumpStart allows you to confirm the integrity of the
installation prior to performing any custom programming. After determining that the
hardware is properly installed, custom programming can be performed. Refer to
Section 8.
NOTICE TO USERS, INSTALLERS, AUTHORITIES HAVING JURISDICTION, AND
OTHER INVOLVED PARTIES: This product incorporates field programmable software. In
order for the product to comply with the requirements in the Standard for Control Units and
Accessories for Fire Alarm Systems, UL 864, certain programming features or options must be
limited to specific values or not used at all as indicated below.
Programming Option Menu Item
Permitted in
UL 864 (Y/N)
Possible Settings
Settings Permitted
in UL 864
Misc Options 1 Low AC Report Delay Yes 0–30 hours 1–3
Switch Water Flow Yes latching and non latching latching
Misc. Opt 3 Alarm Verification Yes 1-250 seconds 60-250 seconds