StandDesk MEMORY HANDSET, Manual

Page: 1 / 2

Measurement
Conversion:
Collision
Sensitivity:
HIT:
OH:
OLU:
GLP:
CON:
To wake press any button.
Set Max
Height:
Calibrate
or Reset:
Wake:
Set Min
Height:
Set
Preferred
Heights:
Set Max/Min
Load Capacity:
MEMORY HANDSET
MANUAL
PRESS/HOLD
PRESS/HOLD LED Display shows 15 seconds
15 seconds
HOLD until Display shows
RELEASE then Display shows 60.
RELEASE WHEN LED Display blinks PRESS/HOLD
When desk raises to highest point (120 CM) RELEASE PRESS LED Display shows
PRESS/HOLD 15 seconds
PRESS/HOLD PRESS
PRESS
PRESS
PRESS
PRESS
20 seconds
RELEASE WHEN LED Display blinks PRESS/HOLD
When desk reaches lowest point RELEASE PRESS
PRESS
LED Display shows
ADJUST to 1st preferred height
PRESS PRESS REPEAT steps for remaining settings.
LED Display will show
PRESS/HOLD 20 seconds
PRESS/HOLD 20 seconds
LED Display will show
LED Display will show
ADJUST max/min load capacity using
to exit or PRESS to choose a different (P) setting
OR
OR
PRESS
PRESS to exit or
PRESS to choose a different (P) setting OR
PRESS OR
once to show
PRESS twice to show
to go from inches (1) and cm (0)
PRESS OR to adjust sensitivity (5-30)
then
then
15 is standard, lower the number the more sensitive.
stands for HIT. This protects your desk against collisions that could lead to damage.
if something hits your frame while it is raising or lowering, it will automatically stop and Memory Handset will read
stands for Overheat. This will show up if the desk has had two minutes of constant usage. To resolve, wait 15 minutes for
your desk to cool down.
stands for Overload, this means there is too much weight on your frame. Either remove some weight or change the load
capacity on your frame in setting
stands for Go to Lowest Position. This means your desk must be re-calibrated.
stands for Connection. One of the frame legs are not working properly. Unplug the device and plug it back in.
Setting One
Setting Two
Setting Three
Menu
LED Display
Up Arrow
Down Arrow
Feel free to reach out with any questions, comments, or concerns. www.standdesk.co/contact
We are always happy to help!