Standard Horizon PC-35, Instruction Manual

Page: 33 / 49

26
6. Maintenance
4 5
6
3
2
1
6-2 Knife Replacement
Clamper Hand Wheel
Clamper
Key Switch
Felt Pen
Front Cover
This section shows how to replace knife.
- Replace knife in the following conditions;
1. Some sheets are left uncut.
2. Cutting noise gets louder.
3. Trimmed sheets are not separated
smoothly.
4. Knife stops during cutting.
6-2-1 Knife Removal
Remove knife to replace it with new one.
WARNING
- Wear gloves when knife is replaced.
- Be careful of knife. Do not touch
knife.
- Knife may cause serious injury.
- Be careful of removed knife. Do not
put it on unstable place with knife bare.
Tools;
1. Felt Pen
2. Box Wrench
3. Two Knife Holder
1.
Turn off power with key switch.
2.
Turn clamper hand wheel to lower
clamper to the bottom.
3.
Make sure knife is on home position.
4.
Open front cover.
5.
Mark knife position on clamper with felt
pen.
NOTE
- This mark is used to adjust knife position.
CAUTION
- When some sheets are left uncut,
knife does not need to be replaced by
adjusting cutting depth, but use of worn
knife cause some troubles. Replace
knife with new one when knife cuts
sheets about 500 times.
6.
Close front cover.