Page 33 of 56
1.23 Configuration Report
This feature is used for troubleshooting only. It allows you to
view the software version for the program in each of the machine
modules: dispensers, EF+ Module, etc. The type and value of
each dispenser will be found here. A software version will be
listed for each module detected. If there is an internet connection
the IP address and subnet mask will be displayed here. This
feature is useful for troubleshooting.
2.0 ERROR CONDITIONS
ERROR CONDITION OVERVIEW
- Error conditions that occur in the machine will be shown on the
EF+ Module display. Error conditions can either be “Soft Errors” which are errors that
DO NOT
result
in the machine going out of service, or “Hard Errors” which are errors that
DO
cause the machine to be
placed out of service. All displayed errors (except
Sold Out, Hardware Added, and Hardware
Removed
) will be stored in the Error Report for viewing. The hardware added and hardware removed
errors mean that a dispenser has been added or removed. Anytime either of these errors occur, be sure
to check ALL vend settings for the correct desired payouts.
BUILT IN HELP
– Help information has been included in the EF+ Module to reduce the need to have
a paper copy of the owner’s manual readily available. This information can be viewed by pressing the
Help (
?
) button while viewing an error message. If this additional information is not available in the
version of software currently installed in your EF+ Module, see the printed version of
“Error Help
Text”
shown below in this document.
RESETTING ERROR CONDITIONS
- Error conditions can be cleared by first resolving the
cause of
the error,
and then pressing the button labeled “RESET” to erase the error message from the display.
To determine the
cause of the error
you must first identify the device that is in error. The device in
error is shown on the top line of display. If there are multiple devices of the same type, it may be
necessary to view the flash code LED on each of the devices to determine which one caused the error.
Once you have identified the device in error, view the error condition (shown on second line of the
display) and read any
Error Help Text
available for that error. Review the section above regarding
“Built In Help” at this time if you have not already done so.
CONFIGURATION
REPORT
EF Module -EF
EF 02.077
Coin disp. -A
25¢ v 2.025
end of
configuration
Bill acc. –A
USA
Pressing the help
button (?) will show you
“The top line is the type
of dispenser and location.
The top line is the
location. The bottom
line is the country.
Summary of Contents for CMP-20
Page 1: ......
Page 2: ...Page 2 of 56 ...
Page 6: ...Page 6 of 56 ...
Page 55: ...Page 55 of 56 NOTES ...
