OPERATIONAL INSTRUCTIONS
WALKING RESISTANCE
The walking resistance or effort needed to push the treadmill belt can be adjusted by changing the incline
angle. This treadmill has two adjustment positions.
Lowest Resistance
Remove (unscrew) the
BUMPER STANDS(17)
from the bottom of the treadmill and store them
in the end of the treadmill.
Highest Resistance
The
BUMPER STANDS(17)
are attached to
the bottom of the treadmill.
NOTE:
The safety and integrity designed into the
Calm® T901 Treadmill
can only be maintained when the
Calm® T901 Treadmill
is regularly examined for damage and wear. Special attention should be given to
the following:
MAINTENANCE
12
1. Since this is a new machine, you may need some time to get used to walking on the treadmill and to
break it in.
2. If the walking resistance is still too high, check the
BELT TENSION
. Refer to page 11 for instructions to
adjust belt tension.
3. The belt resistance can be reduced by adding silicone lubricant between the belt and the board. Wipe
the board under the belt with a clean, dry cloth then spray or spread silicone lubricant on the board
under the belt
.
1. Clean the exposed surfaces of the walking belt and the board with an absorbent cloth.
2. Verify that the
LOCKING KNOB(5)
is present and functioning properly. Repair or replace parts as
necessary.
3. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
4. Verify that the
CAUTION LABEL(47)
is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement
CAUTION LABEL(47)
if it is missing or damaged.
5. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
6. Worn or damaged components shall be replaced immediately or the
Calm® T901 Treadmill
removed
from service until repair is made.
7. Only Stamina Products supplied components shall be used to maintain/repair the
Calm® T901
Treadmill.
8. Keep your
Calm® T901 Treadmill
clean by wiping it off with an absorbent cloth after use.
9. If the
WALKING BELT(14)
does not move easily, lubricate the
BOARD(15)
under the
WALKING
BELT(14)
with silicone lubricant.
