- 21 -
EN
•
enter the equipotential conductor
•
tighten the nut all the way
•
connect the other end of the equipotential cord to the equalizer.
Figure 7. Connecting the unit to an electrical equalizing system.
CAUTION!! During the first use of the device the process of „burning-in” should be performed
in accordance with the below items:
•
install the device according to the above instruction
Hot plates
•
set the control knobs of all plates (Fig.9 pos.2) to ‚6’.
•
wait around 15 minutes, and then begin work
Oven
•
Set the oven control knob to ‚C’ (Fig.11/Fig.12 Pos.3)
•
set the temperature control knob (Fig. 11/Fig. 12 Pos. 4) to the maximum temperature setting (reaching
the set temperature will be signaled by the orange light going out)
•
wait around 15 minutes, and then begin work
After the above process is completed, you can proceed with normal operation with the device. During the
first use of a new cooker, unpleasant odors are released, which result from the natural „burning-in” of the
heaters. These smells will disappear after the first use.
5.
DEVICE OPERATION
Before turning the unit on, make sure that it is properly installed and that its technical condition
is safe for use.
1
2
2
1
1 -
Elements of the front panel controlling the electric oven operation
2 -
Elements of the front panel controlling the electric stove operation
Figure 8. Device control panel
5.1. Operation of hot plates
Hot plates are operated using four/six knobs (depending on the model) on the right hand side
of the control panel.
•
Prior to operation, the control knob (Fig.9 Pos. 2) should be set to “0” .
•
To switch on, turn the knob to the left and set the target temperature (position 1 - minimum power,
position 6 - maximum). The plate heating process is signaled by an orange indicator light (fig.9 pos. 1).
•
The stove is equipped with temperature limiter to reduce the power of heating plates in case of
operation without heat dissipation
•
To switch off the stove, set the knob to “0” clockwise (the indicator light goes off) and disconnect the
power supply.
Summary of Contents for 9705000
Page 53: ......
