Maintenance service
•
Always keep tool and cord clean Adisconnect the pług before cleanlng
•
If the tool should fail despite the care taken in manufacturing and testing
procedures, repalr should be carrled out by an after-sales service centre.
•
send the tool undismantled together with proof of purchase to your dealer or the
nearest authorised service station.
The following information
•
That the declared vibration total value has been measured in accordance with
a standard test methed and may be used for comparing one tool with another;
•
That the declared vibration total value may also be sued in a preliminary assessment
of exposure.
A warning:
•
That the vibration emission during actual use of the power tool can differ from the
declared total value depending on the ways in which the tool is used: and
•
Of the need to identify safety measures to protect the operator that are based on
an estima- tion of exposure in the actual conditions of use (taking account of all arts
of the operating cycle such as the times when the tool is switched off and when it is
running idle in addition to the tri- gger time)
•
Wear ear protectors when impact drilling.
Exposure to noise can cause hearing loss.
NOTE:
The above warning applies only to impact drills and may be omitted ofr drills
other than impact drills.
•
This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision orinstruction concerning use of the
appliance in a safe way and understand the hazards involved.
•
Children shall not play with the appliance. Cleaning and user maintenance shall not
be made by children without supervision
•
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agentor similarly qualied persons in order to avoid a hazard
•
Specify the types, the number of cells and the rated capacity of the batteries that
can be charged;
•
Include a warning against recharging non- rechargeable batteries
CAUTION:
Never attempt to open the battery pack for any reason. If the plastic housing
of the battery pack breaks or cracks, return to a service center for recycling.
PROBLEM SHOOTING
Ways to solve
the problems
Problems
Reasons
The drill
does not
work
Bit cannot
be installed
Motor
overheating
Battery is
depleted
Sleeve is not
released
Be sure cooling
vents are free
from saw dust
and obstacles
Release the
sleeve
Charge the
battery
Clean, clear
vents. Do not
cover with hand
during
operation
PL
EN
ORIGINAL INSTR
UCTION
25
