127303 / 8003607300
2016-05-23·BA00·III·en·05
Commissioning
15
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Panel mounting devices
Series 8003/1
8
Commissioning
Before commissioning, ensure the following:
• Check the mounting and installation.
• Enclosure must not be damaged.
• If necessary, remove foreign bodies.
• Check if the cables have been inserted correctly.
• Check if all screws and nuts have been tightened firmly.
• Check if all conductors have been clamped firmly.
• Check if all prescribed tightening torques have been observed.
9
Maintenance and Repair
9.1
Maintenance
• Consult the relevant national regulations to determine the type and extent of
inspections.
• Adapt inspection intervals to the operating conditions.
At a minimum, check the following points during maintenance work on the device:
• whether the clamping screws holding the cables are securely seated,
• whether the device enclosure and / or protective enclosure have cracks or other visible
signs of damage,
• whether the cable entry seal is damaged,
• whether the permissible temperatures are complied with (according to IEC/EN 60079),
• whether the device is used according to its designated use.
9.2
Maintenance
DANGER
Explosion hazard due to incorrect installation!
Non-compliance results in severe or fatal injuries.
• Check the device for proper installation before commissioning.
• Comply with national regulations.
CAUTION
Risk of electric shock or malfunction of the device due to unauthorized
work!
Non-compliance can result in light injuries!
• Before carrying out work on the device, switch off voltage supply.
• Work performed on the device must only be carried out by
authorized and appropriately trained qualified electricians.
Observe the relevant national regulations in the country of use.
