Stahl Manta GMP 400 Series, Operating Instructions Manual

Page: 14 / 36

Operating Instructions OS-IT-xx9 Safety information
Page 14 of 36

R. STAHL HMI Systems GmbH / OI_IT_xx9_en_V_01_00_07.docx / 06.12.2019
8 Safety information
Read the safety information listed in section 8 carefully to avoid injury
and damage to equipment !
8.1 General safety information

All relevant accident prevention regulations and the rules for electric installations have to
be observed during installation, maintenace and operations. All persons involved in
installation, commission, maintenance and repairs of this device and its accessories must
be qualified accordingly and must have familiarised themselves with this manual and any
associated documentation.

In case of non-compliance or contravention of the above protection is no longer guaranteed
and all warranty claims shall be null and void.

National safety and accident prevention rules apply.

Use the device for its intended purpose only.

No changes to the device are permitted. The enclosure may only be opened by R. STAHL
HMI Systems GmbH.

The first four digits of the serial number on the type plate stand for the year of manufacture.
8.2 Cautionary note
This is a Class A product.
In a domestic environment this product may cause radio interference
in which case the user may be required to take adequate measures.
8.3 Installation safety information

The applicable national assembly and installation rules and the generally accepted technical
rules must be observed. The device and its accessories must be connected and operated
according to applicable standards, directives and installation guidelines. Only quali
fied
personnel or personnel that has been instructed accordingly are allowed to install the
device.

The device has been certified as a fixed, stationary device. The device must be mounted
on a bracket or be fixed to a specified place in another way.

The device may only be moved when it is disconnected from the mains. Keep in mind the
EPL.

Only appropriate tools must be used for the installation.

The wire used for earthing must have a minimum cross section of 4 mm² ! Make sure that
there is equipotential bonding between the devices.

We recommend you use screened cables with the device. Routing of the data cable may
reduce performance.

The maximum voltage of 250 V and a short current of 1500 A must not exceed at the place
of installation.
CAUTION
ATTENTION