Safety
6
272350 / 610260300020
2019-07-25·BA00·III·en·00
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Compact Luminaire with LED
Series C-Lux 6102/1, Series C-Lux 6109/1
3.3
Residual risks
3.3.1 Explosion hazard
Despite the device's state-of-the-art design, explosion hazards cannot be entirely eliminated
in hazardous areas.
Perform all work steps in hazardous areas with the utmost care at all times!
Transport, store, plan, mount and operate the device in compliance with the technical data
exclusively (see the "Technical data" chapter).
Possible hazards ("residual risks") can be categorised according to the following causes:
Mechanical damage
The device can be damaged during transport, mounting or commissioning. This kind of
damage can, for example, render the device's explosion protection partially or completely
ineffective. This may result in explosions causing serious or even fatal injuries to persons in
the vicinity.
Transport the device only in its original packaging or in equivalent packaging.
Check the packaging and the device for damage. Report any damage to R. STAHL
immediately. Do not commission a damaged device.
Store the device in its original packaging in a dry place (with no condensation),
and make sure that it is stable and protected against the effects of vibrations and knocks.
Excessive heating or electrostatic charge
Operation outside of the approved conditions or improper cleaning can result in the device
heating up severely or becoming electrostatically charged and therefore can cause it to
produce sparks. This may result in explosions causing serious or even fatal injuries to
persons in the vicinity.
Operate the device within the prescribed operating conditions only
(see the marking on the device and the "Technical data" chapter).
Install and adjust the device in such a way that it is always operated within the permissible
temperature range.
Do not use the device in strong charge generating environments.
Avoid friction and flow of particle streams.
Clean the device with a damp cloth only.
Improper project engineering, mounting, installation, commissioning, maintenance or
cleaning
Basic work such as installation, commissioning, maintenance or cleaning of the device must
be performed only in accordance with the valid national regulations of the country of use and
only by qualified persons. Otherwise the explosion protection can be rendered ineffective.
This may result in explosions causing serious or even fatal injuries to persons in the vicinity.
Have the mounting, installation, commissioning and maintenance work performed by
qualified and authorised persons only (see chapter 3.2).
Prior to commissioning, check the mounting for correctness (see chapter 7).
Install the device on a level surface only.
