Mounting and Installation
16
222196 / 9176611310
2015-12-22·BA00·III·en·08
Binary Output without Power Supply
Series 9176
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
8.2
Mounting / Dismounting, Operating Position
8.2.1 Mounting / Dismounting of the Device on Top Hat Rail and pac-Bus
Mounting on top hat rail
Mounting on pac-Bus
Dismounting
8.2.2 Mounting / Dismounting on pac-Carrier
Mounting
06886E00
• Position the device on the top hat rail.
Position the cut-out of the enclosure on the outside edge
of the top hat rail.
• Engage the device on the top hat rail.
• When swivelling the device onto the top hat rail,
make sure that it is not set at an angle.
15554E00
The pac-Bus is equipped with a polarisation guide and the
device with a matching slot.
• Position the device as shown in the illustration.
Position the cut-out of the enclosure on the outside edge
of the top hat rail.
• Engage the device on the pac-Bus.
06881E00
• Pull out the base bolt somewhat using a screwdriver.
• Swivel out the device.
12613E00
• Remove the black and green terminals.
• For single-channel devices: remove the covering in
terminal slot 2 (between the black and the green
terminal).