Stahl 6148 Series, Operating Instructions Manual

Page: 18 / 28

Operation
18
206676 / 614860300010
2019-10-10·BA00·III·en·05
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Portable Lamp
Series 6148
9.2.1 Switching the emergency light mode on and off
• Switch the main light on.
• Press button again and keep it pressed.
• Press and hold the button while inserting the portable lamp into the charging unit
and keep holding the button until the LED display shows that a switchover has been
successfully performed.
Explanation of diagram:
• Field completely filled = LED lights up
• Field half-full: LED blinking
• Field empty = LED off
9.3 Charging Operation
9.3.1 Charging the battery
Upon delivery, the "Emergency light mode" function is on.
With the function switched off and in case of power failure, the following states
will be activated at the portable lamp.
red green green green green Description
Emergency lighting function off
Emergency lighting function on
DANGER
Explosion hazard when used in hazardous areas.
Non-compliance results in severe or fatal injuries.
• Only assemble and use the charging unit in safe areas.
At room temperature, the charging time of a discharged battery is
approx. 11 hours.
The portable lamp can remain in the charging unit even when the battery is
completely charged.
before insertion into the charging unit: in case of power failure:
Main LED and secondary LED: OFF Main LED and secondary LED: OFF
Main LED: ON
Main LED: ON
Main LED: DIMMED Main LED: ON
Main LED: BLINKING Main LED: BLINKING
Secondary LED: ON Secondary LED: ON