Batteries
1
2
BACK VIEW
Battery
cover
Battery
cover
BATTERY
INSTALLATION
40677-2203
2 14
RECORDING FINGERPRINTS
When you first receive your safe there are no
recorded fingerprints. For security you must
record a fingerprint. Failure to do so will
compromise the safety and security of the safe.
You can record up to 20 different fingerprints for
opening the safe.
For best results, each individual
should use their thumb or index finger only.
To record a fingerprint, first press the Reset Button on
the inside of the safe. The scanner will turn blue with
two beeps (if the sound is turned on) and the green
light flashes twice, you will then record the same
finger three times as follows:
1. Place your finger on the scanner until there
is one beep (if the sound is turned on) and the
green light flashes once. Lift your finger off
the scanner.
2. Place the same finger on the scanner for a
second time, holding the finger in the same
position until there is one beep (if the sound is
turned on) and the green light flashes once.
Lift your finger off the scanner.
3. Place the same finger on the scanner for a
third time, holding the finger in the same
position until there is two beeps (if the sound is
turned on) and the green light flashes twice.
Lift your finger off the scanner. Your fingerprint
is now recorded.
NOTE: In certain dry climate conditions, your
fingerprint may not scan. If your fingerprint did not
scan, we recommend moisturizing with minimal
lotion and trying again.
SCAN THE SAME FINGER 3X
If the red light flashes three times with three beeps
(if the sound is turned on) your fingerprint did not
get recorded and you will have to start over.
If you enter more than 20 fingerprints, the red light
will flash 5 times and there will be 5 beeps
(if the sound is turned on).
NOTE: The red reset button located on the
inside of the door, is covered with a removable
red cap. When you use the red reset button
while setting your own combination, remove
the cap to access the button.
Replace the cap securely over the reset button
after setting your combination. Failure to do
so will compromise the safety and security of
the safe.
Open the battery compartment located on the
back of the lock faceplate. See illustration below.
After batteries are installed, reattach the faceplate
by twisting it on in the opposite direction of the
illustration on previous page.
